Recent content by JonCamo

Thank you

Thank you. Will take a look

Building inspector visited. I need a building notice of works Planning to use 80mm PIR which is ok to 4 degree slope. Flashing I need to look into/investigate. Suggestions? Is 80mm PIR the rught thicknrmess for a lean to shed?

Hi No The building inspector visited and just showed me the table for rafter spacing for the span width to adhere to

Thank you. I will verify

Any recommendations for the width of the ledger board. I will use 145mm x 47mm rafters at aroumd 5 degree angle so not sure whether to use 175mm or 200mm x 47mm? Regards Jon

That seems pretty straightforward. I had thought to rest it up on temporary screws so at least I am goung about it in the right way Thank you

Thanks. If I use these I presume the stud is screwed directky into the masonry, no 'raw plug' or similar. Resin in drill hole the drive in the stud?

Dear all I have planning permission for my lean to shed. I am going to have a ledger attached to my side wall of my house of either 175mm x 47mm C24 or 200mm x 47mm C24. It will be about 5m long. Off it will come angled rafter brackets for 145mm x 47mm rafters. What fixings would you folk...

Thanks Tom Yes I see your point. Will give the framola kit a try Jon

Thanks Steve Agree they look good. Will give them a go

Thank you. Will take a look

Agree Ollie. Interestibg to hear peoples experiences

Dear all My first project was a green oak gazebo with tenons etc all cut by myself. Very enjoyable but tine consuming. I am hopefully starting a lean to shed project this year but time pressures. It will be against the house wall with wall brackets to attach beams. At the other end I am...