Yes it’s just the mount that is damaged, a bit warped and split in three places. I’ve had a good look online and there’s nothing available. I found an engineer who wants to take on the job of fixing it, I think it can be gerry rigged up to some standard. I wish there was someone who had the part...
I have identified the issue, the mount that holds the cutting block is badly damaged so the block was sitting at an angle to the thicknesser table. I have looked online and it is very difficult to get hold of parts. would anyone know if there is a place i could get a spare, or if anyone would...
It’s a Lurem former 310, I don’t know how similar they are to be honest. I actually have the manual but the one solution it had for my problem wont work for me.
Hey,
I have a Lurem Former 310 and my jointer table isnt level with my thicknesser table, because my knives are squared off the jointer the thicknesser is cutting inacurrately. i have tried adjusting the bolts on the surface planer table to correct this but in order to get them level the...